UA Send a request

← All articles

Overspray: where the coating material goes

Not all the paint from a gun lands on the part. The portion that flies past, or bounces off the surface and settles in the booth, is called overspray. It is coating material you bought but did not get onto the part. On top of that it fouls filters, the booth and the air, and increases the load on ventilation.

Where overspray comes from

There are several causes, and they overlap:

  • Gaps in the part. If the fan hits empty space, all the material flies through it. The worst case is fences, grilles, open-work steel structures and frames.
  • Edges. At an edge of the part some of the fan goes beyond it.
  • Distance and pressure. Too long a distance and too high a pressure scatter the material so that it does not reach the surface.
  • Spraying switched on at the wrong moment. If the gun works during a transition between passes or a turn, the material goes nowhere.

Why open-work parts are especially hard

The fan has a certain width, for example a few centimetres, while a fence post is much narrower. The thinner the element and the bigger the gap, the larger the share of material that flies through the part. A painter goes around each element by hand, but keeping the spray exactly on the element and not beside it, over a large number of posts, is hard. The result: the part is painted, and a large part of the material used stays on the floor and walls of the booth.

What can be changed in the motion itself

The type of gun affects overspray, but not only that. It matters just as much where and how the fan works:

  • whether spraying switches on only when the gun faces an element of the part, not empty space;
  • what distance to the surface and what fan width are chosen for that particular element;
  • how the passes are built: along the posts or across them, at what speed and overlap;
  • whether spraying switches off during the transitions between passes.

When the toolpath is built from a scan of the real geometry, the cell knows where there is metal and where there is a gap. It can switch spraying on only on the elements and off during idle transitions. This is a design goal of our system. We have not yet confirmed it on physical equipment.

How to track it

What is not measured is hard to improve. We are designing records: pressure and flow sensors log how much material went into a cycle, and the system stores the parameters of every painting run and a log of cycles. Then consumption can be compared between parts and settings rather than estimated by eye or by what is left in the drum.

Records also have a practical side: you can see which setting uses less for which part and change parameters with data instead of at random.

What we do not promise

We state no savings percentage. It depends on the shape of the part, the material, the equipment and the settings, and it can be confirmed only in a pilot at a real plant. In Inducoat Studio there is a scenario-based estimate of possible coating material savings from your own assumptions. It is a calculator, not a test result, and we label it that way in the interface.

What to check on your side

To understand whether overspray is a problem for you, it helps to count:

  1. How much coating material you buy per month and how much actually ends up on the parts (even roughly, by weight before and after).
  2. On which parts the losses are more noticeable: are any of them open-work?
  3. What filters and booth maintenance cost.

These numbers will help you, and us, in a conversation about a pilot.